when i open toribash,it automaticly Opens shader"from Profile.tbs"

but when i try to open Ray Tracing in the OPITION , it goes wrongly like this :-



Why Does It like that not like normal and the textures and force isnt shown so bad?

it happens with me
you must deactivate Shaders and ray tracing option then restart to toribash and activate them
if not you must restart you PC or unistall toribash a install it again

tell me if it works

none of these opitions worked...any other suggestions?

maybe you must PM a moderator

I think your Video Card doesn't fully support Ray-Tracing for Toribash, check here. May I see your stderr.txt?

Bla bla,my graphic card runs shaders so fast,and no errors in shader so what about the raytracer?btw my vga card is ati raedon 545V

Are you sure the drivers are up to date?

Is up to date tried "device doctor"program and it stays that my whole pc is updated

ATI drivers are often the cause of problems like this - and updating them can be the worst thing to do at times.

See if there's newer ones on the ATI/AMD site, and also try older ones. They have a nasty habit of breaking things that used to work.

For reference, shaders & raytracing work perfectly for me with Catalyst 11.12; driver v 2011.1109.2212.39826 (I hate their numbering)